RIGHT STOP WB HEAVY DUTY is a high performance water based treatment that utilizes a combination of siloxanes to seal concrete against moisture and deleterious salts. RIGHT STOP WB HEAVY DUTY is especially useful for protecting steel reinforcements within concrete slabwork from corrosion caused by water and chloride salts. The service life of reinforced concrete is significantly extended when the steel reinforcements are protected from corrosion.
This environmentally friendly VOC compliant compound is designed to penetrate deep into concrete surfaces, sealing against moisture and preventing damage due to deicing salts.
• ASTM-E 514-90
RIGHT STOP WB HEAVY DUTY is suitable for any concrete, stucco, brick, or other type of masonry that requires protection from weathering and moisture damage.
• Steel reinforced concrete
• Concrete block
• Precast concrete
• Masonry surfaces
• Seals concrete against moisture and deleterious salts
• Extends service life of reinforced concrete
• VOC compliant
• Reduces spalling and scaling
• 1 Gallon 6 Pack
• 5 Gallon Pail
• 55 Gallon Drum
||75 sq ft/gal
||100-150 sq ft/gal
The appropriate time of application on concrete, for the maximum penetration of the sealer, is after the final cure phase; most effectively after 28 days of curing. Before application of RIGHT STOP WB HEAVY DUTY, clean surface stains and clear the surface of debris. For the most effective use of the sealer, it is important to ensure that the surface of the concrete is completely dry; excess moisture will interfere with the penetration of the material.
Once the surface is clean and dry, spray one coating of RIGHT STOP WB HEAVY DUTY over the surface of the concrete; saturating the surface is recommended. RIGHT STOP WB HEAVY DUTY may be applied with a standard hand held sprayer with neoprene hose and gaskets; a short napped roller is recommended for brush application. If ponding occurs, smooth out the puddles with a broom or roller.
A second application of RIGHT STOP WB HEAVY DUTY may be necessary for especially porous concrete or masonry, and can be applied after 1-2 hours. Restrict foot traffic until surface is completely dry.