Right Finish

Right Finish
Polymer Modified Cement Based Finish



 

  Right Finish
SDSspacerPDF

 

DESCRIPTION
RIGHT FINISH is a polymer modified cement based coating designed to enhance the finished appearance of precast, tilt up and other unfinished concrete surfaces.

USE AND APPLICATIONS
• Tilt up concrete
• Concrete pipe
• Precast
• Masonry surfaces
• Floor repair

FEATURES AND BENEFITS
• Single component
• Fills honeycombs and bug holes
• Long working time
• Uniform color– Light Gray
• Use on walls and floors

PACKAGING
• 40 lb Bag

Coverage Rate
• One (1) 40 lb bag will yield approximately .40 cubic feet

APPEARANCE
• Light Gray

SHELF LIFE
• Minimum of one (1) year stored in dry protected storage

DIRECTIONS FOR USE
The surface must be clean, sound and free of debris. On non porous surfaces, abrasion may be required to improve adhesion. Always pre-wet surfaces prior to installation.

MIXING
RIGHT FINISH will require 4 to 5 quarts of water per bag. Always add the powdered mixture to the liquid. Mix with a jiffy mixer until a creamy consistency is achieved.

APPLICATION
Trowel or float to a uniform finish. RIGHT FINISH can be used from a featheredge to 1/8". Moist cure in hot windy weather. Do no use solvent based Chemical Liquids. For applications greater than 1/8", use RIGHT CRETE THIN REPAIR.

CLEAN UP
Clean tools immediately with water after use. The polymer in this mix will make it very difficult to remove once cured.

RESTRICTIONS
Do add the RIGHT FINISH powder to the water.
Do protect from rain for 24 hours after application.
Do not re-temper.
Do not use under 40 degrees.

 
 

MATERIAL PROPERTIES

ASTM C109
Compressive Strength
  7 Day 3000 psi
  28 Day 4500 psi
ASTM C78
Flexural Strength
  7 Day 500 psi
  28 Day 750 psi
ASTM C1042
Bond Strength
  7 Day 1000 psi
  28 Day 1450 psi
ASTM C266
Initial Set (Exterior @ 75 °) 30-45 Minutes
Initial Set (Interior @ 75 °) 60-90 Minutes

NOTE: Cooler weather will delay set time.

TECHNICAL SERVICE
For conditions not specified, application procedures not noted, contact: Right Pointe, LLC (888) 755-5700.

LIMITED WARRANTY
Every reasonable effort is made to apply Right Pointe, LLC exacting standards both in the manufacture of our products and in the information which we issue concerning these products and their use. We warrant our products to be of good quality and will replace or, at our election, refund the purchase price of any products proved defective. Satisfactory results
depend not only upon quality products, but also upon many factors
beyond our control. Therefore, except for such replacement or refund, Right Pointe, LLC MAKES NO WARRANTY OR GUARANTEE, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, RESPECTING ITS PRODUCTS, and Right Pointe, LLC shall have no other liability with respect thereto. Any claim regarding product defect must be received in writing within one (1) year from the date of shipment. No claim will be considered without such written notice or after the specified time interval. User shall determine the suitability of the products for the intended use and assume all risks and liability in connection therewith. Any authorized change in the printed recommendations concerning the use of our products must bear the signature of the Right Pointe, LLC Technical Manager.

 

 

 
   

ABOUT US

 

OUR PRODUCTS
Expansion Joints and Plastics
Waterproofing

Joint Sealants
Chemical Liquids
Cementitous Products
Roofing

 

CONTACT US

 

FEATURED PRODUCTS

 
© 2017-2019 All Rights Reserved Right Pointe, LLC.