RIGHT CRETE SPEED REPAIR is a general purpose patching material that requires only water for mixing. It achieves initial set in 10 minutes and final set in 20 minutes. RIGHT CRETE SPEED REPAIR can be shaved to level the repair back to a uniform condition. This material has high strength, has excellent bond and weathers well.
• Concrete pipe
• Precast repair
• Concrete steps
• Curbs without forming
• Ideal for vertical and overhead repairs
• Can be shaped and molded
• 28 day strengths in excess of 5000 psi
• Mix with water only
• Pleasing light gray color when cured
• 50 lb Bag
• One (1) 50 lb unit will yield approximately .50 cubic feet
• Light gray option
• Concrete gray option
• Minimum of one (1) year stored in dry protected storage
Remove all dirt, grease, oil and other contaminants that may come in contact with the patching material. For horizontal patching, a 3/4" saw cut is recommended to insure adhesion. Always pre-wet to a saturated surface dry (SSD) condition with no standing water on the surface.
Mix only as much material as can be placed in 5 to 7 minutes. Always add the powder to the water. Approximately 5 to 6 quarts of water per unit is suggested, never exceeding 6 quarts. RIGHT CRETE SPEED REPAIR may be mixed with a margin trowel for small repairs. Use a jiffy mixer or mortar mixer for larger repairs. Mix RIGHT CRETE SPEED REPAIR for no more that 60 seconds. Mix to a no slump consistency. Do not re-temper the material.
Always overfill the area to be patched. Once initial set has occurred, shave the patch to its desired finish. Always shave towards the bond lines. Finish with a steel trowel. RIGHT CRETE SPEED REPAIR is ideal for patches from 1/4" and up. For featheredge repairs, use RIGHT CRETE THIN REPAIR.
Clean tools with water immediately after use.