Clear Water Wax
Clear Water Wax


  Clear Water Wax


CLEAR WATER WAX CONCRETE CURING COMPOUND is a water based coating that utilizes a refined petroleum wax base to form a watertight membrane on concrete surfaces.
This environmentally friendly VOC compliant compound is designed to provide maximum curing to freshly-laid interior/exterior concrete paving applications.
• VOC compliant with maximum 350 g/l content
• Excellent for interior applications
• Will not clog or plug spray equipment
• Ready to use

• ASTM-C 309, Type I, Class A
• AASHTO M148, Type I, Class A

CLEAR WATER WAX is suitable for use with a wide variety of concrete construction projects. It is also ideal for many sizes of interior/exterior concrete slab work, as well as other flatwork applications
• Industrial/commercial flooring
• Roadways
• Airport runways
• Parking lots
• Curbs

• Membrane forming treatment enhances slab water retention
• Densifies and hardens concrete, reducing any crazing, cracking or checking
• Tensile and compressive strengths are improved over non-cured slabs
• Packaging stable with no hard settlement

• 5 Gallon Pail
• 55 Gallon Drum
• 275 Gallon Tote

Coverage Rate
Approximate............................................................................200 sq ft/gal

For newly placed concrete, apply CLEAR WATER WAX when surface water has completely disappeared from the surface. It is also recommended that application not be attempted until workmen cannot mar the surface. Temperature must be above 40° F before application. CLEAR WATER WAX may be applied with a standard hand held sprayer or power sprayer; a short napped roller is recommended for brush application. Avoid puddling during application and restrict foot traffic for at least four (4) hours (12 hours preferable) after application. Additional coatings may be applied after surface has completely dried.


Drying Time
Four (4) hour minimum (12 hours recommended).

Water based, incompatible with solvent containing products.
Ready to use - DO NOT DILUTE.
For optimum results, light mixing is recommended (excessive agitation will cause foaming).
Spray evenly in a one coat application after the surface is free of all bleed water.
Use a spray rate of approximately 1/2 gallon per minute, not exceeding 45 PSI of pressure with any conventional piece of spray equipment.
Clean up is accomplished with warm soapy water.

Water based. Do not allow to freeze.
Use only when concrete temperature exceeds 40° F for 24 hours.
Refer to the Safety Data Sheet for additional health and safety information.

For conditions not specified, application procedures not noted, contact: Right Pointe, LLC (888) 755-5700.

Every reasonable effort is made to apply Right Pointe, LLC exacting standards both in the manufacture of our products and in the information which we issue concerning these products and their use. We warrant our products to be of good quality and will replace or, at our election, refund the purchase price of any products proved defective. Satisfactory results depend not only upon quality products, but also upon many factors beyond our control. Therefore, except for such replacement or refund, Right Pointe, LLC MAKES NO WARRANTY OR GUARANTEE, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, RESPECTING ITS PRODUCTS, and Right Pointe, LLC shall have no other liability with respect thereto. Any claim regarding product defect must be received in writing within one (1) year from the date of shipment. No claim will be considered without such written notice or after the specified time interval. User shall determine the suitability of the products for the intended use and assume all risks and liability in connection therewith. Any authorized change in the printed recommendations concerning the use of our products must bear the signature of the Right Pointe, LLC Technical Manager.







Expansion Joints and Plastics

Joint Sealants
Chemical Liquids
Cementitous Products







© 2017-2019 All Rights Reserved Right Pointe, LLC.